Milky Way™ Dragon Egg Soap Mold (MW 558)
Inspired by the Game of Thrones Dragon Egg, this soap mold is perfect for fans of the show or dragon enthusiasts! Paint with mica paint for the ultimate whimsical affect!

Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold.

Bath Fizzies: Tightly pack bath fizzy mixture into each mold cavity. Allow to harden and dry. (For best results, leave in mold overnight). Flip mold over onto clean surface and gently push bath fizzies out of mold.

Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Country Of Origin: United States


Directions:
When making CP Soap coat the mold with cooking spray or line with plastic. Pour soap into mold. Unmold after 24 hours. When making MP Soap pour the melted soap into mold (do not use cooking spray or plastic). Cool until firm. Wrap soap immediately after unmolding. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments

Ingredients:
International Nomenclature of Cosmetic Ingredients (INCI):
This product does need to be listed on the product ingredient label.

Common Name Ingredient Listing (FDA Approved):
This product does need to be listed on the product ingredient label.

Available Sizes:
$6.95 for 1 Mold
$29.95 for 5 Mold
$95.95 for 20 Mold
$385.70 for 150 Mold (Bulk)