Celtic Dragons Soap Mold (MW 327) - Wholesale Supplies Plus
 
25% Off Scents 8 Oz and Up! - Shop Now
 
 
Wholesale Supplies Plus
 
   
 
OUR BRANDS:
 
 

Milky Way™

Celtic Dragons Soap Mold (MW 327)


Document IconProduct Details

According to Celtic folklore, dragons influenced the lay of the land. It is said that the locations that the dragons frequented are areas with a special power. These frequent paths are known as 'ley lines'. The Celtic Dragons Soap Mold features two of these powerful wingless dragons in a square design.

Common Uses:
Melt & Pour Soap. Cold Process Soap. Lotion Bars.

Points of Interest:
Manufacturer: Milky Way Molds
Material: Clear PVC (Not Approved for Food Contact)
Country of Origin: United States

Milky Way Soap Molds can tolerate temperatures of 135-145 degrees F. Above these temperatures, warping may occur. Soap is easiest to release 12-24 hours after cooling. 

Wash molds in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Helpful Product Information:
Material: Plastic Style: Bar
Avg. Bar Weight: 3.95 oz Bar Cavities: 3
Bar Depth: 3/4" Bar Length: 3"
Bar Width: 3" Max Temperature: 135ºF



Directions:
Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold.

Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Product Information:

Brand Milky Way™
Country Of Origin United States

CA Prop 65

Documents:

Non-Hazardous Statement Animal Testing Statement

Clipboard IconRecipes & Videos (0)

Question Mark IconQuestions & Answers (0)

Comment IconCustomer Reviews (1)

Photo IconCustomer Photos

Levels IconCharts & Calculators