Banana Flower MP Soap Recipe

Banana Flower MP Soap Recipe

Crafted with a delicate banana flower design, this melt and pour soap recipe brings together elegant artistry and gentle cleansing in a beautifully...

Crafted with a delicate banana flower design, this melt and pour soap recipe brings together elegant artistry and gentle cleansing in a beautifully handcrafted bar.

Read More Read Less

By Melissa Eldridge Jun 10, 2026

Yield: 6 bars

Est Time: 3 hours

Level: Moderate

Jump To Directions
Shopping List
Directions

Step 1

Place the shea butter MP soap on your cutting board. Cut it into small pieces using the soap cutter.

Step 2

Add the base to the funnel pitcher. Melt the soap in 30-second intervals, stirring in between each 30-second burst. Melt the soap only until it is in a fluid state.

Step 3

Add 0.5 oz. of the Banana Flower and Sol Fragrance Oil. Stir.

Step 4

Pour 2 oz. of the melted soap into each cavity of the silicone square mold. Spray the soap with alcohol to remove any air bubbles.

Step 5

To the remaining soap, add just a very small amount of the yellow dye block. Stir.

Step 6

Pour the soap into the silicone flower molds. Spray the soap with alcohol and allow the soap to set up before removing it from the mold.

Step 7

Cut up 25 oz. of the clear melt and pour soap base. Again, melt in 30-second intervals only until the soap is in a fluid state.

Step 8

To the clear melted soap, add 0.5 oz of the Banana Flower and Sol Fragrance Oil.

To Use

Wet the skin and rub the bar of soap on your skin or onto a washcloth to create a lather, then rinse thoroughly with water.