Grapefruit & Thyme MP Soap Loaf Recipe

Grapefruit & Thyme MP Soap Loaf Recipe

By wholesale supplies plus Jan 29, 2026

Yield: (8) Slices

Est Time: 1 Hour

Level: Moderate

Jump To Directions
Shopping List
Directions

Step 1

To microwave-safe measuring cup, add 5 oz. of cut up Detergent Free Clear Soap Base. Heat in microwave in 30 second increments until melted.

Step 2

Add (2) 0.15 ml scoops of Martini Olive Green Mica and 4 ml of Peach Grapefruit & Thyme Fragrance Oil. Blend well to incorporate.

Step 3

Pour into loaf mold and spritz with alcohol. Let harden.

Step 4

Weigh and cut up 8.25 oz.of DF Clear Soap Base. Heat in microwave in 30 second increments until melted.

Step 5

Add (3) 0.15 ml scoops of Mai Tai Orange Mica and 6 ml of fragrance.

Step 6

Pour into the smaller round silicone mold (1803) and fill all cavities. Set aside leftover soap to be used in a later step.

Step 7

Weigh and cut up 16.5 oz. of DF Clear Soap Base. Heat in microwave in 30 second increments until melted.

Step 8

Add (9) 0.15 ml scoops of Siesta Sunset Mica and 14 ml of fragrance oil. Fill all cavities in the 1802 silicone mold (larger round ball). Set aside leftover soap to be used in a later step.

Step 9

When the soap has hardened in the 2 round ball silicone molds, remove from molds and set aside. Remelt the leftover soaps and fill up as many cavities as you can. Allow to harden and then unmold.

Step 10

Weigh and cut up 14 oz. of Detergent Free Three Butter Soap Base. Heat in microwave in 30 second increments until the soap has melted. Add 12 ml of fragrance and stir well.

Step 11

Spritz the green layer of soap with rubbing alcohol.

Step 12

Spritz a handful of the peach and orange soap balls and place on top of the green soap. We found it was best to put the flat side down towards the base or to the sides of the mold wherever possible.

Step 13

Pour the melted white soap on top of the colorful balls until just covering the layer. Be sure the soap temperature is 130°F or cooler.

Step 14

Repeat steps 13 and 14 until the mold is filled. We placed some of the bubbles so that they were sticking out of the top of the loaf. If you do this make sure that they are sitting in enough soap so they will not fall off when unmolding.

Step 15

Spray the top with alcohol to pop any surface bubbles and then allow to harden.

Step 16

Slice soap and package as desired.

Step 17

Label accordingly.

To Use

Lather onto skin and rinse with warm water.

Ingredient Label

Sorbitol, Propylene Glycol, Sodium Laureth Sulfate, Stearic Acid, Myristic Acid, Water, Sodium Hydroxide, Sodium Cocoyl Isethionate, Titanium Dioxide, Fragrance, Mica, Chromium Oxide Green, Yellow 10, Red 28, Red 22.